Hello Everyone, confusing symptom with my R30...When scanning immediately after power on, no audio is emits when on a active signal. After going through the menus and verifying proper mode selection, I did a partial reset. Upon doing so, radio scans and opens squelch normally. I find the Auto setting works best so excessive tight squelch is not the problem. This occurs every time I power the unit up. Guess it needs to go back to Icom, any idea of out of warranty cost?? Terrific little...
No receive audio when scanning and on active signal, must frequently partial reset
No receive audio when scanning and on active signal, must frequently partial reset
Aucun commentaire:
Enregistrer un commentaire